Filter
Top Products
Nordic Zone Salad Bar Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.deleld.com
2
Nordic Zone Salad Bar Service and Installation Manual
3
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.deleld.com
RECEIVING AND INSPECTING UNIT................................................. 2
INSTALLATION.................................................................................. 3
ROUTINE MAINTENANCE ................................................................. 3
OPERATION ...................................................................................... 4
WIRING DIAGRAM............................................................................ 5
REPLACEMENT PARTS LIST............................................................. 5
FULL VIEW........................................................................................ 6
UNIT DETAILS................................................................................... 7
WALL MOUNT INSTALLATION.......................................................... 8
STANDARD WARRANTIES...........................................................9-10
AUTHORIZED PARTS DEPOTS........................................................ 12
©2003 The Deleld Company. All rights reserved. Reproduction without written permis-
sion is prohibited. “Deleld” is a registered trademark of The Deleld Company.
The serial number on Nordic Zone series is located behind the hinge
doors afxed to the interior stainless side. On the two section model,
it will be the two interior sides in the center of the assembly.
Always have the serial number of your unit available when calling for
parts or service. A complete list of authorized Deleld parts depots is
shown on the back cover of this manual.
Refrigeration system is set up as a R-404a refrigerant.
Units are shipped blanket wrapped.
Care should be taken during unloading so the equipment is not
damaged while being moved into the building.
1. Visually inspect the unit. Any damage should be noted and
reported to the delivering carrier immediately.
2. If damaged, open and inspect the unit with the carrier.
3. In the event that the unit is not damaged, yet upon opening,
there is concealed damage to the equipment notify the carrier.
Notification should be made verbally as well as in written
form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10 days
from receipt of the equipment.
5. Also open the mechanical compartment housing and visually
inspect the control package. Be sure lines are secure and
base is still intact.
6. Freight carriers can supply the necessary damage forms upon
request.
RECEIVING AND INSPECTING THE EQUIPMENT
CONTENTS
SERIAL NUMBER LOCATION
MODEL PRODUCT #OF # OF REMOTE REMOTE SHIP WEIGHT
NUMBER LENGTH HOLDING AREA DOORS LIGHT BULBS AMP HP BTU LBS.
NZ123 123.5” (313.69cm) 24” x 80.5” (60.69cm X 204.47cm) 4 (4) 48” 6 1.5 10,030 951
NZ207 207” (525.78cm) 24” x 124” (60.69 x 410 cm) 8 (8) 48” (2) 6 (2) 1 1/2 20,060 1600
Mechanical Data (dimensions for RT00012 (left side) and RT00013 (right side) combined