Filter
Top Products
5
Versa Drawer™ Refrigeration Units
Deleld · 980 S. Isabella Road, Mt. Pleasant, MI 48858 · (989) 773-7981 or (800) 733-8829 · Fax (989) 773-3210
INSTALLATION
Never stand on the unit or its drawers! Doing so may
result in bodily injury.
LOCATION
Units represented in this manual are intended for
indoor use only. Be sure the location chosen has
a oor strong enough to support the total weight of
the cabinet and contents, which can be up to 1,200
pounds. Reinforce the oor as necessary to provide for
maximum loading.
The location should be selected so that power cords
can be connected without any extension cords.
For the most efcient operation, be sure to provide
good air circulation inside and out. Avoid hot corners
and locations near stoves and ovens.
Direct exposure to excessive amouns of steam in
machine compartment will result in board failure.
INSIDE CABINET
Do not pack drawer so full that air cannot circulate.
Load product level with top of pans and keep all food
covered.
OUTSIDE CABINET
The front louvers must be kept 24" clear of any
obstructions. Proper operation of these models is
dependent on air being able to ow freely through the
front louvers. Side louvers must have 24" of clearance
for service access.
Any restriction of the proper airow outlined above,
total or partial, will void the warranty on the unit.
LEVELING
The unit must be level so the drain pan will drain
properly, drawers will line up with frames and the
cabinet will not be subject to undue strain.
STABILIZING
All models are supplied with legs or casters installed
for your convenience, for ease of cleaning underneath.
The unit must be installed in a stable condition.
PLUMBING
All models are standard with a condensate evaporator
pan.
ELECTRICAL CONNECTION
ELECTRICAL CONNECTIONS AND GROUNDING
CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL
ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
UNITS EQUIPPED WITH A FLEXIBLE ELECTRIC
SUPPLY CORD ARE PROVIDED WITH A
THREE-PRONG GROUNDING PLUG. THIS PLUG
MUST BE CONNECTED INTO A PROPERLY
GROUNDED THREE-PRONG RECEPTACLE. IF THE
RECEPTACLE IS NOT THE PROPER GROUNDING
TYPE, CONTACT AN ELECTRICIAN. DO NOT
REMOVE THE GROUNDING PRONG FROM THIS
PLUG.
A 7' (2.1 m) long grounded supply cord with three-
pronged plug is provided with the standard units.
Simply plug into a three-pronged wall outlet for proper
grounding of the unit to begin operation.
Refer to the amperage data listed in the specications,
the serial number tag, your local code or the National
Electrical Code to be sure the unit is connected to the
proper power source. A protected circuit of the correct
voltage and amperage must be installed for connection
of the line cord or permanent connection to the unit.
Have the wall outlet checked by a qualied electrician
to be sure a proper ground is present and that the
outlet provides the correct voltage and required
amperage to match the specications. Do not use an
adapter to connect to a two-pronged outlet. The three-
pronged-outlet provides a ground connection that must
be used to prevent a shock hazard.
Any power cord that is frayed or damaged should be
replaced. When disconnecting the unit from the power
source, do not pull on the cord. Firmly grip the plug
and remove from outlet.
The unit must be disconnected from the power
source whenever performing service, maintenance
functions or cleaning the refrigerated area.