Filter
Top Products
3
Downloading and installing the Dell
OpenManage Plug-in Version 1.0 for
Nagios Core
1. Download the latest Dell OpenManage Plug-in Version 1.0 for Nagios Core installer from the Dell
support website at support.dell.com or from Nagios exchange at exchange.nagios.org/.
The installer is packaged as a .tar.gz file named
Dell_OpenManage_Plugin_v1.0_Nagios_Core_A00.tar.gz.
2. Save the folder you have downloaded in a desired directory.
3. Navigate to the directory where you have downloaded the folder, and run the following command to
extract its contents:
tar -zxvf Dell_OpenManage_Plugin_v1.0_Nagios_Core_A00.tar.gz
The following folder and files are extracted:
• Dell_OpenManage_Plugin folder
• Dell_OM_Plugin_1_0_For_NagiosCore_IG.pdf file
• Dell_OM_Plugin_1_0_For_NagiosCore_ReadMe.txt file
• license_en.txt file
4. Navigate to the Dell_OpenManage_Plugin/Install folder, and then run the following command to
invoke the installer:
./install.sh
5. Press Y if Nagios Core version 3.5.0 or later is installed in your system, or press any other key to exit
the installation process, install Nagios Core version 3.5.0 or later and then begin the installation
process once again.
Alternatively, you can press Enter to continue with the default value (Y).
6. When prompted for the installed Nagios Core location, provide the path, and then press Enter.
Alternatively, you can press Enter to continue with the default location, /usr/local/nagios.
An invalid entry will display an error and exit the installation process.
NOTE: If Net-IP or both Net-SNMP and OpenWSMAN are not installed in your system, then the
installation process will exit. Ensure that the prerequisites are met and then begin the
installation process once again.
If any of the other prerequisites are not met, then the installation procedure will display an
appropriate message and continue with the installation.
7. Press Y if you accept the End User License Agreement, or any other key to exit the installation.
Alternatively, you can press Enter to continue with the default value (Y).
8. Press Y to set the attribute escape_html_tags to ‘0’, or press N to continue with the default setting,
‘1’.
Alternatively, you can press Enter to continue with the default value (N).
8