Filter
Top Products
support.dell.com Dell PowerEdge Cluster FE100/FL100 Platform Guide 3
•
PowerEdge 6450-6350
•
PowerEdge 8450-6350
•
PowerEdge 8450-6450
NOTE: Both nodes must be configured with identical operating systems and service
packs, similar drivers (network interface controllers [NICs], Fibre Channel host bus
adapter [HBAs], and so on), utilities (Dell OpenManage™ system management soft-
ware, and so on), and Fibre Channel HBA basic input/output system (BIOS).
!"#
Table 1 lists the QLogic HBAs and the PowerEdge servers on which they are sup-
ported for Windows NT cluster configurations. For PCI slot recommendations, see
the section for your server model on adding peripherals required for cluster nodes,
found later in this document.
NOTE: All QLogic HBAs used in the cluster nodes must be the same model.
The supported drivers for the QLogic HBAs in Windows NT configurations are as
follows:
•
For QLA-2100/ 33-MHz, version 7.04.08 or later
•
For QLA-2200/ 33-MHz, version 7.04.08 or later
•
For QLA-2200/ 66-MHz, version 7.04.08 or later
You can download the latest drivers from the Dell Web site at
http://www.dell.com
.
#$%&'
Windows NT Service Pack 6a or later is recommended for PowerEdge Cluster FE100/
FL100 systems.
PowerEdge
Servers 2400
2450
4300/
4350 4400 6100
6300/
6350
6400/
6450 8450
QLogic
HBAs
QLA-2100/
33-MHz
xxx
QLA-2200/
33-MHz
xx x x x x x
QLA-2200/
66-MHz
xxx
96etttb0.book Page 3 Thursday, July 6, 2000 9:36 AM