Filter
Top Products
14
USE AND CARE
USING THE OVEN FOR THE FIRST TIME
Operate as follows:
■ Assemble the wire racks on the oven
walls using the 2 screws interposing
the catalytic panels “A” with the arrow
up (g. 9a). The catalytic panel with the
hole for the side oven lamp must be po-
sitioned on the left oven wall. DO NOT
INTERPOSE THE CATALYTIC PANEL
WITHOUT THE HOLE ON THE LEFT
OVEN WALL.
■ Slide in the grease lter on the back of
the oven as in g. 10.
■ Slide into the guides, the shelf and the
tray (g. 9b).
The rack must be tted so that the safe-
ty notch, which stops it sliding out, faces
the inside of the oven; the guard rail shall
be at the back.
The tray must be tted so that the safe-
ty notch, which stops it sliding out, faces
the inside of the oven.
■ To eliminate traces of grease in manu-
facture it is necessary to preheat the
oven at the maximum temperature:
• For 60 minutes in the position, for
30 minutes in the
position and for
another 15 minutes in the
position.
■ Unscrew the xing screws and slide off
the wire racks and the catalytic liners to
the oven wall as in g. 9a.
The grill is secured to the rear wall of the
oven on a hinge system that allows it to
be lowered to allow proper access when
cleaning the oven ceiling (see next chap-
ter TILTING GRILL).
■ Let the oven cool down, switch off the
electrical supply, then clean the inside of
the oven with a cloth soaked in water and
neutral detergent and dry thoroughly.
CAUTION:
■ This appliance must be used only for the task it has explicitly been designed for, that
is for domestic cooking of foodstuffs. Any other form of usage is to be considered as
inappropriate and therefore dangerous.
■ Do NOT place combustible materials or products on this appliance at any time.
A
A
Figure 9a
Figure 9b
Stop notch
Stop notch
Guard rail