Filter
Top Products
Installation Safety PrecautionsCare and Cleaning
Electrical Connection
This appliance should be properly grounded for
Ÿ
your safety. The power cord of this appliance is
equipped with a three-prong plug which mates
with standard three prong wall outlets to minimise
the possibility of electrical shock.
DO NOT UNDER ANY CIRCUMSTANCES CUT
Ÿ
OR REMOVE THE EARTHING CONNECTION
FROM THE POWER CORD SUPPLIED. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
Please look at the rating label to know the rating
Ÿ
voltage and connect the dishwasher to the
appropriate power supply. Use the required fuse
10 amp, time delay fuse or circuit breaker
recommended and provide separate circuit
serving only this appliance.
Ensure the voltage and frequency of the power
Ÿ
being used corresponds to those on the rating
plate. Only insert the plug into an electrical socket
which is earthed properly. If the electrical socket to
which the appliance must be connected is not
appropriate for the plug , replace the socket, rather
than using a adaptors or the like as they could
cause overheating and burns.
The cord should be secured behind the appliance
Ÿ
and not left exposed or dangling to prevent
accidental injury.
The appliance should always be plugged into its
Ÿ
own individual electrical outlet which has a voltage
rating that matches the rating label on the
appliance. This provides the best performance and
also prevent overloading house wiring circuits that
could cause a fire hazard from overheated. Never
unplug the appliance by pulling the power cord.
Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately
all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows
cracks or abrasion damage along its length or at
either end. When moving the appliance, be careful
not to damage the power cord.
Extension Cord
WARNING: DO NOT USE AN EXTENSION CORD
Ÿ
OR AN ADAPTER PLUG WITH THIS APPLIANCE.
Grounding Instructions
This appliance must be earthed. In the event of a
Ÿ
malfunction or breakdown, earthing will reduce the
risk of electric shock by providing a path of least
resistance for the electric current. This appliance
is equipped with a cord having an equipment-
earthing conductor and an earthing plug. The plug
must be plugged into an appropriate outlet that is
installed and earthed in accordance with all local
standards and requirements.
WARNING
Improper connection of the equipment earthing
Ÿ
conductor can result in the risk of an electric shock.
Check with a qualified electrician or service
Ÿ
representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the
Ÿ
appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a
proper outlet.
Page 7Page 26
3
STEP 3: Lift the Fine Filter up.
NOTES:
When following this procedure from step 1 to step
Ÿ
3, the filter system will be removed; when following
it from Step 3 to Step 1, the filter system will be
installed.
Inspect the filters for blocking after every time the
Ÿ
dishwasher has been used.
By unscrewing the coarse filter, you can remove the
Ÿ
filter system. Remove any food remnants and clean
the filters under running water.
The entire filter assembly should be cleaned once a
Ÿ
week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a
cleaning brush. Reassemble the filter parts as shown
in the figures on the last page and reinsert the entire
assembly in the dishwasher, positioning it in its seat
and pressing downwards.
Caring for the Dishwasher
The control panel can be cleaned by using a lightly
dampened cloth. After cleaning, make sure to dry it
thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door, you should use
only a soft warm, damp cloth.
To avoid penetration of water into the door lock and
electrical components, do not use a spray cleaner of
any kind.
WARNING!
Never use a spray cleaner to clean the door panel
Ÿ
as it may damage the door lock and electrical
components.
Abrasive agents or some paper towels should not
Ÿ
be used because of the risk of scratching or leaving
spots on the stainless steel surface.