Filter
Top Products
22
PROGRAM FOR AUTOMATIC
SWITCHING OFF OF A COOKING
ZONE
This function permits to set a timer from “ 1 ”
to “ 99 ” minutes for automatic turning Off the
cooking zone/s.
With the cooktop switched On:
■ Select the cooking zone and set the de-
sired power level.
■ Within 8 seconds, touch the timer key
“
CL ” (the led indicating the programmed
zone starts blinking) and set the timer:
– The display reads “
0- ”: set the se-
cond digit of the timer by using the
setting selector. If the value shall be
zero touch the display and the second
digit ( 0 ) will start ashing. Touch the
display to conrm o wait a few secon-
ds till the programmer automatically
turns to the next step.
– When the display reads “ -Z ” (where
“ Z ” indicates the second digit pre-
viously set): set the rst digit of the
timer by using the setting selector. If
the value shall be zero touch the di-
splay and the rst digit ( 0 ) will start
ashing. Touch the display to conrm o
wait a few seconds till the programmer
automatically turns to the next step.
– The program is now processed (led
indicating the programmed zone ste-
ady lit).
■ The time can be changed at any time fol-
lowing the same procedure here above
indicated (selecting previously the coo-
king zone).
■ To program another cooking zone, repe-
at as described above.
Now the program for automatic switching Off
is complete.
At the end of the countdown the cooking
zone will switch Off automatically, an acoustic
signal (beep) will sound (for 2 minute only),
“
00 ” will ash on the timer display and the
led next to the heater display will blink.
Touch one of the keys to stop the beep.
Figure 20
Figure 21
Figure 22
Figure 23