Filter
Top Products
3
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce
risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot sur-
faces. Use handle when moving this heater. Keep combustible materials, such as furni-
ture, pillows, bedding, papers, clothes and curtains at least 3 feet (0,9 m) from the
front and top of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any appliance is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug appliance when not in use.
5. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical or
mechanical adjustment, or repair.
6. Do not use outdoors.
7. Do not use this heater in the immediate proximity of bathrooms, laundry areas and simi-
lar indoor locations. Never place appliance where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, run-
ners, or the like. Arrange cord away from traffic area and where it will
not be tripped over.
9. To disconnect the appliance, turn controls to off, then remove plug from outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation opening as this may
cause an electric shock, fire or damage the appliance.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
13. A fan heater has hot or arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored.
14. Use this appliance only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into
the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord
which becomes hot to the touch or becomes distorted in shape may be a result of a
worn electrical outlet (receptacle). Worn outlets or receptacles should be replaced prior
to further use of the heater. Plugging heater into a worn outlet/receptacle/ may result
in overheating of the power cord or fire.
17. Do not use an extension cord because the extension cord may overheat
and cause a risk of fire. However, if you have to use an extension cord, the
cable cord be no. 14 AWG minimum size and rated not less than 1875
watts, and has to be used only for supplying power to this appliance.
18. Be sure that the plug is fully inserted into an appropriate outlet. Please remember that