Filter
Top Products
7
REMOTE CONTROL OPERATION
- When you press the “ON power selection” push button, the appliace operates at the
maximum power. Each further pression of the “power selection” push button, the power
will change from MAX to MED/MIN/MAX.
- If you desire to operate with the fan only, press the “Fan Only” pushbutton.
- Only when a function is selected it is possible to activate the rotation of the appliance,
by pushing the “ON/OFF oscillating base” push button.
- The “Off” push button switches off the appliance.
Every time you press a button, the appliance will confirm the selection with a “beep” and
the pilot light on the remote control will illuminate.
FLOW DIRECTION (Tilting Body)
The appliance inclines or declines manually so that air is flowing in the desired direction.
IMPORTANT
In the event of a blackout , the appliance settings will be reset.
To turn the appliance back on, repeat the procedure described above.
MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the heater to cool. After the heater has
cooled, clean it with a soft damp cloth, do not use detergents or abrasives. Periodically clean
the air intake and outlet grilles during the period in which the heater is in use with a vacuum
cleaner.
Should the heater not be in use over a certain length of time, store it in a dry place.
This appliance has been built to provide many years of trouble free service.
In case of malfunction, do not try to repair the heater yourself: it may result in fire hazard or
electric shock. Call the nearest Service Center (see attached list of Service Centers).
ATTENTION
A safety device turns the fan heater off if it accidentally overheats. An audible signal warns of
that overheating has occurred. To reset the unit to normal operation, remove the plug from the
outlet for a few minutes, eliminate the cause of overheating (e.g. obstructed air intake or outlet
grilles) and then plug the fan heater back in again. Contact your nearest Service Center if the
fan heater does not resume normal operation again.
ON power selection
pushbutton
Fan Only pushbutton
ON/OFF oscillating base
pushbutton
Off
Pilot light