Filter
Top Products
13
9 PREPARING ESPRESSO/COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS)
•Press the button (fig. 16) to select the ground coffee function. This disables the coffee mill function.
The appliance displays:
READY PRE-GROUND
• Lift the lid in the center, place one measuring scoop of ground coffee in
the funnel (see fig. 17) and proceed as described in section 5.
Note: you can make just one coffee at a time by pressing the ,
or button once only.
• After using the appliance with pre-ground coffee, to go back to making coffee using beans, deactivate
the ground coffee function by repressing the button to prepare the grinder for operation again.
NOTE 1: Never add the ground coffee when the appliance is off to avoid it from being dispersed inside the
appliance.
NOTE 2: Never add more than one level measuring scoop, otherwise either the
appliance will not make the coffee, the ground coffee will be lost inside the applian-
ce, dirtying it, or the coffee will run off in drips and the message "GROUND TOO FINE
ADJUST GRINDER AND TURN STEAM KNOB" will be displayed.
NOTE 3: When dosing the quantity of coffee to be added, use the measuring scoop supplied only.
NOTE E: Do not use freeze-dried coffee or other materials that could damage the appliance
NOTE: If the funnel blocks due to moisture inside the appliance or if more than one measuring scoop of pre-
ground coffee has been used, use a knife to push the coffee down (Fig. 18), then remove and clean the infu-
ser and appliance as described in paragraph 15.2 "Cleaning the infuser".
10 PRODUCING HOT WATER
•Always make sure the appliance is ready.
• Make sure the water spout is attached to the nozzle (fig. 4);
• Position a container under the spout (fig. 3).
•Press the button (fig. 1).
The appliance displays:
HOT WATER
and hot water is delivered from the water spout into the container below (you should not run off hot water
for more than two minutes at a time). To stop the flow, press the button. Once the set quantity of hot
water has been reached, delivery stops automatically.