EC220
CLEANING and MAINTENANCE: FILTERDELIVERING HOT WATER
Delivering hot water
1
.
Place a container under the spout
(as close as possible to avoid splashes).
2
.
Turn dial
to
position
and wait until
OK light turns green.
3
.
Turn dial
to position
and turn the
steam dial counter-clockwise. Water
runs out of the spout.
4
.
Close the steam dial and turn the dial
to
position
when the desired amount
of water has been delivered.
Important! Danger of burns.
Never leave the machine unsupervised while
delivering hot water or steam. The spout becomes
hot during delivery. Hold by the handle only.
Remove steel filter cup from
the steel filter holder.
1
5A
Unscrew cap from the
steel filter cup.
Remove gasket from the
steel filter cup.
3
2
4
Remove the filter from the
the gasket.
5 6
7 8
Replace the
filter and plastic
disk into the
gasket. Make
sure to insert
the pin on the
plastic disk
into the hole in
the gasket.
Remove the stainless-steel
filter off the plastic disc.
Clean steel filter with a brush
and the holes with a needle.
Replace the
assembly in the
steel filter cup,
making sure the
pin is inserted in
the hole in the
support. Finally,
screw on the
cap.
Note: If the filter is not cleaned and assembled properly, it could effect the crema
of the espresso. The filter assembly must be cleaned (every 200 coffees.)
9 10