Filter
Top Products
9
B12. light: grounds container full
B13. light: general alarm
B14. Rinsing or descaling button with light
B15. ECO energy saving mode button with light
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the
product is complete and undamaged and that all
accessories are present.
Do not use the appliance if it is visibly damaged.
Contact Customer Service (see enclosed guaran-
tee leaflet).
Installing the appliance
Important!
When you install the appliance, you should fol-
low the following safety warnings:
• Theappliancegivesoffheat.
After positioning the appliance on the
worktop, leave a space of at least 3 cm
between the surfaces of the appliance and
the side and rear walls and at least 15 cm
above the coffee maker.
• Waterpenetratingtheappliancecouldcause
damage.
Do not place the appliance near taps or sin-
ks.
• Theappliancecouldbedamagedifthewater
it contains freezes.
Do not install the appliance in a room where
the temperature could drop below freezing
point.
• Arrangethepowercableinsuchawaythatit
cannot be damaged by sharp edges or con-
tact with hot surfaces (e.g. electric hot pla-
tes).
Connecting the appliance
Important!
Check that the mains power supply voltage cor-
responds to the value indicated on the rating pla-
te on the bottom of the appliance.
Connect the appliance to an efficiently earthed
and correctly installed socket with a minimum
current rating of 10A only.
If the power socket does not match the plug on
the appliance, have the socket replaced with a
suitable type by a qualified professional.
Using the coffee maker for the first time
Please note:
• Coffeehasbeenusedtofactorytesttheap-
pliance and it is therefore completely normal
for there to be traces of coffee in the mill. The
machine is, however, guaranteed to be new.
• You should customise water hardness as
soon as possible following the instructions
in the section “Setting water hardness” on
page 15.
1. Remove the water tank, fill to the MAX line
with fresh water then replace in the appliance
(fig. 1).
2. Turn the cappuccino maker outwards and
place a container with a minimum capacity
of 100 ml underneath (fig. 2).
3. Plug the appliance into the mains socket and
place the main switch on the back of the ap-
pliance in the I position (fig. 3).
4. Press the button (fig. 4); IMMEDIATELY
AFTERWARDS(WITHINAMAXIMUMOF30
SECONDS),turnthesteamknobanticlockwi-
se as far as it will go (fig. 5). This is priming
the water system. (It is normal for the ma-
chine to make some noise).
5. Wait for delivery of hot water to stop auto-
matically. The lights flash to indicate that you
must close the steam tap by turning the ste-
am knob to the 0 position.
6. Turn the steam knob to the 0 position. The
appliance goes off automatically.
To use the appliance, turn it on.
Please note:
• Whenusingtheapplianceforthersttime,
you need to make 4-5 cups of coffee or 4-5
cappuccinos before the appliance starts to
give satisfactory results.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the
main switch on the back of the appliance is in the
I position (fig. 3).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which can-
not be interrupted.
The appliance is ready for use only after comple-