Filter
Top Products
15
EN
MAKING MILK-BASED
DRINKS
Filling and attaching the milk
container
1. Turn the lid of the milk container clockwise
until it becomes noticeably difficult to turn,
then remove the lid.
2. Fill the milk container with a sufficient quanti-
ty of milk, not exceeding the MAX level
marked on the handle (fig. 15).
NB!
You should ideally use skimmed or
2% milk at refrigerator temperature (about 41°F).
3. Make sure the milk intake tube (B4) is cor-
rectly inserted in the bottom of the milk con-
tainer lid (fig. 16).
4. Replace the milk container lid and turn coun-
terclockwise as far as it will go.
5. Remove the hot water spout from the nozzle
(fig. 17).
6. Attach the container to the nozzle, pushing as
far as it will go (fig. 18).
7. Place a sufficiently large cup under the coffee
spouts (A14) and the frothed milk spout (fig.
19). If necessary, move the frothed milk spout
slightly outwards (B5 - fig. 19).
Making cappuccino
1. Fill the milk container (B) with milk and attach
it as described in the section "Filling and
attaching the milk container".
2. Position the milk frother slide (B1) between
the words CAPPUCCINO and CAFFELATTE
printed on the milk container lid cover. The
quantity of froth can be adjusted by moving
the slide towards the word CAFFELATTE for a
denser froth. Moving it towards the word
CAPPUCCINO obtains a less dense froth.
3. Press the cappuccino button (fig. 22). The
message "Cappuccino" is displayed. (After a
few seconds, frothed milk runs out of the milk
spout into the cup below. Run off of milk
stops automatically and run off of coffee
begins.)
N.B.!
If you want to stop preparation, press
the CAPPUCCINO button twice. Pressing it once
stops frothed milk run-off, pressing it twice stops
coffee run-off.
Making frothed milk
1. Fill the container (B) with milk and attach it as
described in the section "Filling and attaching
the milk container".
2. Set the frothed milk regulator (B1) to the
quantity of froth required.
3. Press the CAPPUCCINO button (fig. 22) twice.
The message "Milk Frothing" is displayed.
NB!
If you want to stop preparation of
frothed milk, press the CAPPUCCINO button once.
Making caffelatte
1. Fill the container (B) with milk and attach it as
described in the section "Filling and attaching
the milk container".
2. Set the frothed milk slide (B1) to CAFFELAT-
TE.
3. Press the CAPPUCCINO button (fig. 22). The
message "Cappuccino" is displayed.
NB!
If you want to stop preparation of caf-
felatte, press the CAPPUCCINO button twice.
Making hot milk
1. Fill the container (B) with milk and attach it as
described in the section "Filling and attaching
the milk container".
2. Set the frothed milk slide(B1) to CAFFELATTE
3. Press the CAPPUCCINO button (fig. 22) twice.
The message "Milk Frothing" is displayed.
NB!
If you want to stop preparation of hot
milk , press the CAPPUCCINO button once.
"Less dense"
froth
NO froth
"Denser" froth
regulator