Filter
Top Products
16
Programming the quantity of coffee
and milk in the cup for cappuccino
or frothed milk
The appliance is factory preset to automatically
deliver 2.4oz of frothed milk and 2.7oz of coffee.
To modify these quantities, proceed as follows:
1. Place a cup under the coffee spouts and the
frothed milk spout (fig. 19).
2. Press and hold the CAPPUCCINO button for at
least eight seconds (fig. 22). The message
"Milk for Cappuccino Program Quantity" is
displayed.
3. Release the button. The appliance starts run-
ning off milk.
4. Once the required quantity of milk has been
run off into the cup, press the CAPPUCCINO
button again.
5. After a few seconds, the appliance starts run-
ning off coffee into the cup and the message
"Coffee for Cappuccino Program Quantity" is
displayed.
6. Once the required quantity of coffee has been
run off into the cup, press the CAPPUCCINO
button again. Coffee run-off stops and "READY"
is displayed.
The machine is now reprogrammed with the new
quantities.
Cleaning the milk container after
use
Clean the internal tubes of the milk container each
time you use it to avoid the build-up of milk
residues or blockages.
Important! Danger of burns
When cleaning
the internal tubes of the milk container, a little hot
water leaks out of the frothed milk tube (B5).
Avoid contact with splashes of water.
1Place a cup or other container under the
frothed milk spout (B5 - fig. 19);
2. Press the "CLEAN" button (B3 - fig. 20) and hold
it down for at least eight seconds. The message
"Cleaning" is displayed.
3. Remove the milk container and clean the noz-
zle with a sponge (fig. 21).
HEATING WATER
Preparation
Important! Danger of burns.
Never leave
the machine unsupervised while running off hot
water. As shown below, stop run-off of hot water
when the cup is full. The hot water spout becomes
hot while water is running off and must be han-
dled by the handle only.
1. Make sure the hot water spout (B7) is
attached correctly (fig. 3).
2. Place a container under the spout (as close as
possible to avoid splashes).
3Press the button (fig. 1). The message
"Hot Water..." is displayed. Water runs out of
the spout.
NB!
Stop the flow of hot water by pressing
the button.
Important:
You should not run off hot
water for more than two minutes at a time.
Changing the quantity
The appliance is factory preset to automatically
deliver 8.5oz. To modify these quantities, proceed
as follows:
1. Position a container under the spouts.
2. Press and hold the button down for 8 sec-
onds. The message "Hot Water Program
Quantity" is displayed.
•When the hot water in the cup reaches the
required level, press the button again.
The machine is now reprogrammed with the new
quantity.