Filter
Top Products
Thank you for choosing this De’Longhi citrus press.
To get the best results from your new citrus press it is
advisable to read these instructions carefully before using
the appliance.
This is the only way to ensure optimum results and maxi-
mum safety.
Using for the first time
• Before use, check that the appliance has not been damaged dur-
ing transport.
• Remove all packaging from the citrus press.
• Check that the voltage of the electrical socket corresponds to
the voltage indicated on the label on the appliance. Before using
the appliance for the first time, carefully wash and dry the fruit
dome, filter,container and non-drip spout
Assembling the appliance
Assemble the appliance as follows:
1. Insert the two ends of the juicing lever into the guides (fig. 1).
2. Make sure the juicing lever is mounted correctly by raising and
lowering the lever.
3. Insert the cover into the lever ring and push as far as it will go,
making sure the tab on the ring fits into the hole in the cover
(fig. 2).
At this point, the appliance is ready for juicing.
Before use
Before using the machine for the first time, wash all the acces-
sories (dust cover,fruit dome, top filter, bottom filter,pulp density
selector, internal juice container,non-drip spout) in warm soapy
water and rinse.
Use
•Place the container on the motor base.
• Fit the bottom filter and top filter.
• Place the filter assembly on the motor base , making sure the
pulp density selector is positioned in the hollow in the motor
base (fig. 3).
• Fit the fruit dome onto the motor shaft.
• Place a glass under the non-drip spout and move the spout
downwards (fig.4).
• Plug into the mains.
• Cut the citrus fruit in half.
• Place half a fruit onto the fruit dome and lower the cover by
pushing the juicing lever down and pressing lightly.
The motor is designed to rotate in either direction to optimise
the juicing effect; press the juicing lever intermittently the
motor will reverse its rotational direction.
fig.2
Fig.3
Fig.4
Citrus juicer KS3000
3
fig.1