DeLonghi KS3300M Blender User Manual


 
Kettle KBX3030
Electrical Requirements
The flexible mains lead is supplied connected to a B.S. 1363 fused
plug having a fuse of 13 amp capacity.Should this plug not fit the
socket outlets in your home, it should be cut off and replaced with
a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and
should therefore be properly disposed of, (having removed the
fuse) and not left where children might find it and plug it into a
supply socket - with the obvious consequent danger.
If the plug is a moulded-on type the fuse cover must be refitted.If
the fuse cover is lost, the plug must not be used until a replace-
ment cover is obtained.The colour of the correct replacement
fuse cover is that of the coloured insert in the base of the fuse
recess or elsewhere on the plug.Always state this colour when
ordering a replacement fuse cover.
N.B.We recommend the use of good quality plugs and wall sockets
that can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the termi-
nals in your plug,proceed as follows:
The wire which is coloured green and yellow must be connect-
ed to the terminal in the plug which is marked with the letter E
or by the earth symbol or coloured green or green and yel-
low.
The wire which is coloured blue must be connected to the ter-
minal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the ter-
minal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are secure-
ly retained in each terminal. Do not forget to tighten the mains
lead clamp on the plug. If your electricity supply point has only
two pin socket outlets, or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require replacement, it is essential
that this operation be carried out by a qualified electrician and
should only be replaced with a flexible cord of the same size.
Only 13amp replacement fuses which are ASTA approved to B.S.
1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding
the suppression of radio interference.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp
Warning
this appliance must be earthed
6