Filter
Top Products
8
ASSEMBLING LVC STARTER
BOX TO CABINET
If you purchased the machine with magnetic push
button electrical controls, the saw is shipped with the
starter box completely wired to the switch and motor.
However, the starter box must be mounted to the saw
cabinet. To assemble the starter box (A) Fig. 7, to the
saw cabinet, proceed as follows:
1. Place a 1/4" lockwasher onto a 1/4-20x1/2" hex
head screw, place a 1/4" flat washer onto hex head
screw. From the inside rear of the saw cabinet, insert the
1/4-20 x 1/2" hex head screw into the hole (B) Fig. 7, in
the cabinet. Repeat this process for the two remaining
screws.
2. Line up the three tapped holes (C) Fig. 7, in the
starter box with the screws and secure the starter box
(A), to the saw cabinet.
3. Figure 8 illustrates the starter box (A) assembled to
the saw cabinet.
Fig. 7
Fig. 8
ASSEMBLING LVC ON/OFF
SWITCH
1. Locate the LVC switch and hardware that was
removed in the section “ASSEMBLING EXTENSION
WING.”
2. Mount the switch bracket (C) Fig. 10, to the inside of
through hole D) on the left front edge of the extension
wing with the hardware that was removed.
NOTE: If you have a GPE switch see “ASSEMBLING
GPE ON/OFF Switch” instructions.
Fig. 9
Fig. 10
B
A
C
A
C
D
A