Filter
Top Products
11
Fig. 22
Fig. 23
Fig. 25
Fig. 24
Fig. 26 Fig. 27
A
P
B
X
Z
Y
8. Assemble upper splitter bracket (M) Fig. 22, to lower
bracket (L) using a 5/16-18x1" hex head screw (N) with
5/16" lockwasher and 5/16" flat washer. NOTE: Do not
tighten screw (N) at this time.
9. Insert the front end of splitter (P) Fig. 23, inside the
splitter mounting bracket behind splitter fastener plate
and screw (C). Push splitter down as far as possible,
making certain the bottom edge of splitter (P) is parallel
with the table surface. Tighten screw (C). Fasten splitter
and blade guard assembly (P) Fig. 24, to bracket (M)
using a 5/16-18x1" hex head screw (V) and 5/16" flat
washer.
10. IMPORTANT: The splitter (P) Fig. 25, features a notch
(W) cut into the top edge. Raise the front of the clear
blade guard (P) Fig. 25, until the rear edge of the guard
slips into notch (W) of the splitter. This notch enables the
blade guard to stay in the raised position and makes
changing blades easier.
11. Reassemble the saw blade, making certain the teeth
are pointing down at the front of the saw table as shown
in Fig. 26, and assemble the outside blade flange and
arbor nut (X). With open end wrench (Y) on the flats of the
arbor to keep it from turning, tighten arbor nut by turning
box end wrench (Z) counterclockwise.
N
M
L
M
V
P
P
W
P
C