Filter
Top Products
9
ASSEMBLING GPE ON/OFF
SWITCH
1. The GPE on/off switch (A) Fig. 11, is shipped
attached to a mounting bracket at the right side of the
machine.
2. Loosely assemble switch and switch bracket (A) Fig.
12, to the inside front lip of extension table with 5/16-
18x1" flat head screw (D), 5/16" flat washer (E), and 5/16
hex nut (F) through hole (G).
3. Attach the side of switch bracket (A) Fig. 13, to the
inside of extension table at the front of the saw using the
7/16-20x1-1/4" screw (C) and 7/16" flat washer. Tighten
screws (C) and (D).
Fig. 11
Fig. 12
Fig. 13
D
C
A
Fig. 14
Fig. 15
A
C
B
ASSEMBLING BLADE
GUARD AND SPLITTER
ASSEMBLY
CAUTION: DISCONNECT MACHINE FROM POWER
SOURCE.
1. Remove the table insert Fig. 14. Raise the saw arbor,
by turning the locking handle on the front of the saw,
counter clockwise and then turn the wheel on the front of
the saw clockwise as far as it will go, and remove the saw
blade from the machine by following the instructions in
section “CHANGING THE SAW BLADE”.
2. The inside splitter mounting bracket (A) Fig. 15, is
assembled to the inside of the saw and aligned with the
inside blade flange (B) at the factory.
3. To check the alignment, remove screw and fastener
plate (C) Fig. 15. Using a straight edge (D) Fig. 16, check
to see if the splitter bracket (A) is aligned with the inside
blade flange (B). Check both the top and bottom of
bracket (A) with the top and bottom of flange (B).
A
F
E
D
G
A