Filter
Top Products
MODELS: GBR50L / GBR80L
Page 2.
1-6. Fasten suspension brackets to joists with nails or
screws through holes near nails.
1-7. Secure suspension brackets together with screws.
Joist
Joist
Bottom of Joist
Screw
2. DUCT CONNECTION
2-1. Insert the duct into the duct connector and tape all
ductworks connection to make them secure and air
tight.
2-2. Install the duct with a gradient 1°~2° to the outside.
Inside
Outside
Duct
Body
Gradient
1°~2°
Grille
Tape
Ceiling
3. CONNECT WIRING
3-1. Follow all local electrical and safety codes.
3-2. NEVER place a switch where it can be reached from a
tub or shower.
3-3. Connect wires as shown in wiring diagrams.
(BLUE)
LIGHT
(BLK)
FAN
WHT
WHT
BLU
BLK
LIGHT
SWITCH
FAN
SWITCH
BLK
WHT
GRD
LIGHT/FAN ELECTRICAL BOX
LINE
IN
HOUSE ELECTRICAL BOX
3-4. Using wire nuts (not provided), connect house
power cable to ventilating fan.
3-5. 14 AWG (2.1 mm
2
) is the smallest conductor that
shall be used for branch-circuit wiring.
4. TEST RUN & GRILLE ATTACHMENT
4-1. When the power on, check for abnormal vibration or
sound.
4-2. Insert the grille bracket into the main body, and lock
screw (M4×6) to x on the main body.
Screw M4 x 6
4-3. Mount the grille to the grille bracket by screw
(#8-32×1-1/4”).
Lock Screw
#8-32 x 1-
1
4
"
4-4. Install light bulbs and attach the cover.
GU24 Lamp (26W Max.)
Lock lens cover
5. OPERATION
5-1. Turn on the power switch to operate ON or OFF, and
LED indicator is green. Turn on the power to operate
main light on/o.
6. MAINTENANCE
WARNING:
Disconnect power source before working on unit. Routine
maintenance must be done every year.
CAUTION:
1. Never use gasoline, benzene, thinner or any other
such chemicals for cleaning the ventilating fan.
2. Do not allow water to enter motor.
3. Do not soak resin parts in water over 60°C.
CLEANING：
1. Open lens cover. Remove the light
bulbs carefully.
Disassemble the screw (#8-32×1-1/4”), and light
power connections to remove grille.
2. Wash and clean grille. CAUTION: Do not let water
into the lamp base. (Use non-abrasive kitchen
detergent, wipe dry with a new cloth.)
3. Using a cloth dampened with non-abrasive kitchen
detergent, remove dust and dirt from ventilating fan.
Wipe dry with new cloth.
4. Replace grille.
DIMENSIONS
1111""
1111""
88""
88
11
44
""
55
33
44
""
4" DUCT
8
1
4
"
5
3
4
"
2
1
2
"
11"
11"
SPECIFICATIONS
Model No.
Voltage
(V)
Frequency
(Hz)
Power
(W)
Air Flow
@ 0.1SP
(CFM)
Weight
(lb.)
Note
GBR50L 120 60 33.1 50 6.4 Light
GBR80L 120 60 40.1 80 6.4 Light
Note: Design and specications subject to change without notice.
WARRANTY
DELTA ELECTRONICS THREE YEAR LIMITED WARRANTY
Delta Electronics Inc. (”Delta Electronics”) warrants to the
original consumer purchaser in the USA that the Breez
ventilation fan products will be free from defects in
material or workmanship. This warranty is limited to three
(3) years from the original date of purchase.
Limitations and Exclusions
1. During the warranty period, a replacement for any
defective product will be supplied free of charge for
installation by the consumer. The warranty provided
herein does not cover charges for labor or other costs
incurred in the troubleshooting, repair, removal, and
installation service.
2. All returns of defective parts or products must include
the product model number, and must be made through
an authorized Delta Electronics distributor. Authorized
returns must be shipped prepaid. Repaired or
replacement products will be shipped by Delta
Electronics F.O.B. shipping point.
3. Delta Electronics shall not be liable for any indirect,
incidental, consequential, punitive, or special damages
arising out of or in connection with products use or
performance, regardless of the form of action whether in
contract, tort (including negligence), strict product
liability or otherwise.
4. This warranty does not extend to uorescent lamp
starters and tubes.
5. The warranty does not cover if user does not comply
with manufacturer’s installation manual.
6. To qualify for warranty service, you must notify Delta
Electronics at the address or telephone number below.
7. Delta Electronics shall have no liability to the original
owner-user with respect to any defect caused by abuse,
misuse, neglect, improper transportation or storage,
improper testing, improper installation, improper
operation, improper use, improper maintenance,
improper repair, improper alteration, improper
modication, tampering or accident of products or parts
thereof, or unusual deterioration or degradation of
products or parts thereof due to a physical environment
beyond the requirements of product’s specications.
Address: 4405 Cushing Parkway, Fremont, CA 94538 US
Toll Free Number: 1-888-979-9889
Duct
Connector