Filter
Top Products
www.desatech.com
119668-01A4
GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a
plug as shown in Figure 2. An adapter is available
for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding plug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 2 - Grounding Methods
Figure 3 - Electric Stove Control Panel
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a
ground electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for power
supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit
(see Figure 3).
1. Main ON/OFF Power Switch: This switch
is located at the furthest right corner on
the control panel when looking at the back
of the unit. Turn the switch to ON and unit
will be ready to operate. The "|" indicates
ON and "O" indicates OFF.
IMPORTANT: Once you turn
the main switch to the ON posi-
tion, the remote control can no
longer be used. In order to use
the remote control, you must
keep the main ON/OFF switch
in the OFF.
2. Ember Control Dial: There is a divided
circle under this dial. After you turn the
Main Power switch to the ON position, turn
the Ember Control Dial to desired setting.
This dial controls the intensity of the light-
ing under the ember bed.
3. Flame Control Dial: There is a ame picture
under this dial. Turn this dial to adjust the
ame intensity.
4. Heater Switch and Control Dial: The heater
switch has a sun directly below it. To turn the
heater on, ip Heater Switch to ON position
( "|" indicates ON and "O" indicates OFF).
The Control Dial has a thermometer below it.
Turn dial clockwise past the number 8. You
should hear a small clicking sound indicat-
ing the heater has started and heat will emit
through vents located at the top of unit. To turn
off heater, turn the temperature dial counter
clockwise past number 1 and flip Heater
Switch to OFF position.
To increase the desired temperature, turn
temperature dial clockwise towards Num-
ber 8.
To decrease desired temperature, turn
temperature dial counter clockwise towards
number 1. The heater has a built-in thermo-
stat so it will shut off automatically once set
temperature is reached. It will also turn on
automatically if room temperature drops
below the set temperature on dial.
Note: When the heater is turned on for the
rst time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again. (Some
odor may occur when dust settles on the unit
and is burned off).
OPERATING BY REMOTE CONTROL
1. Plug in your electric replace and it will
beep once. This means you have power
and your remote is ready to operate your
electric replace.
IMPORTANT: To control the
electric replace by remote, the
Main ON/OFF power switch on
the replace must be in the OFF
position; the remote control will
NOT work if the manual ON/OFF
switch is in the ON position.
Ember Control
Dial
Main Power Switch
Flame
Control Dial
Heater Switch
Heat Control
Dial
Grounding Pin
Adapter