Filter
Top Products
a
CABINET ADJUSTMENTS
To change door panel
The refrigerator is normally delivered without door
panel(s).
Before starting the mounting work check
that the panel dimensions are in compliance with
those given in the table and read the instructions
through. When
mounting the panel, proceed as
follows:
1.
2.
3.
4.
5.
6.
Remove the
top decoration strip (2) with
two screws
(1).
its
Insert one
of the vertical edges of the p
anel
into the groove of the door frame (3).
Bend the panel gently so that the free side of
the panel can be slipped into the corresponding
groove of the door frame (4).
Push the panel downwards so that the lower hori-
zontal edge of the panel is fitted into the
bottom groove (5).
Between the upper edge of the panel and the door
frame
there is now a gap which should be covered
by the decoration strip.
Put the strip across the door so that the gap
is covered and push it upwards (6).
The tabs on the inside of the strip should fit
in behind the flange of the door frame. Secure
the decoration strip by means of the two screws (1).
Panel dimensions
Thickness max.
5/32"
Height
Width
Type
Max. Min.
Max.
Min.
RM 360
636
633 516,5 513,5
mm
25"
24
7/8"
20
11/32"
20
7/32"inch
RM
460
679
676
26
23/32"
550,5 547,5
26
19/32"
21
11/16"
21
9,16":ch
RM 660
879
876
550,5 547,5
mm
34
5/8"
34
l/2"
21
11/16"
21
9/16"inch
RM 760
288
285
550,5 547,5
mm
upper
11
11/32"
11
7/32"
21
11/16"
21
9/16"inch
RM 760
801
798
550,5 547,5
mm
lower
31
17/32"
31
13/32"
21
11/16"
21
9/16"inch
Fig.8