Filter
Top Products
12
Defrosting
As time goes by, frost builds up on the fins.
When the layer of frost is about 3mm thick, the refrigerator should be defrosted.
1. Switch off the refrigerator, as described in section “6.6 - Switching off".
2. Remove the ice cube tray and food.
3. Leave the refrigerator door open.
4. After defrosting (freezer compartment and fins free of frost), wipe the cabinet dry
with a cloth.
5. Use a cloth to mop up the water from the freezer compartment.
6. Switch the refrigerator back on again.
The layer of ice must never be removed forcibly, nor may defrosting be
accelerated using a heat source.
Note:
Water thawing in the main compartment of the refrigerator runs into an appropriate
container at the back of the refrigerator. From there, the water evaporates.
6.4
6.5
1. Loosen the front
and back securing
brackets.
2. Move the storage rack to the left and
remove it.
Dismantling:
To fit the storage rack, the reverse order applies.
Positioning the storage rack
6.6
1. Set energy selector switch (A)
to position "0" (OFF). The
appliance is now fully switched off.
2. Leave the door open.
It shall be slightly ajar.
This is to prevent mould
from forming inside
the appliance.
A
Switching off gas operation
If the refrigerator is to be taken out of service for an extended period of time,
the on-board shut-off valve and the cylinder valve must be closed.
Switching off
1.
2.