Filter
Top Products
- 3 -
This appliance is certifi ed under the latest edition of ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel. The installation
must conform with local codes, or in absence of local codes, the following standards as applicable.
In the U.S. the installation must conform with:
National Fuel Gas Code, ANSI Z223.1/NFPA 54
(latest edition).
Recreational Vehicles Code, ANSI A119.2 (latest edition).
Manufactured Home Construction and Safety Standard, Title
24 CFR, Part 3280.
If an external electrical source is utilized, the refrigerator, when
installed, must be electrically grounded in accordance with
local codes or, in the absence of local codes, the National Elec-
trical Code, ANSI/NFPA 70 - (latest edition).
•
•
•
In CANADA, the installation must conform with:
Natural Gas and Propane Installation Code, CSA B149.1
CSA Z240 RV Series, Recreational Vehicles.
Current CSA Z240.4, Gas-equipped Recreational Vehicles
and Mobile Housing.
If an external electrical source is utilized, the refrigerator,
when installed, must be electrically grounded in accordance
with local codes or, in the absence of local codes, the Canadian
Electrical Code, CSA C22.1, Parts I and II - (latest edition).
•
•
•
CERTIFICATION AND CODE REQUIREMENTS
VENTILATION REQUIREMENTS
Certifi ed Vent System Kits
Model
Kit No.
Components
Part no.
RM2351
RM2354
2A
3A
Roof Base
Roof Cover
Lower Side Vent
Lower Side Vent
Upper Side Vent
Lower Side Vent
Power Vent Asm.
Upper Side Vent
Upper Side Vent
Lower Side Vent
Lower Side Vent
3103633.XXX*
3103634.XXX*
3109350.XXX*
RM183
RM123A
RM183
3108705.751**
RM123A
3109492.003
RM183
3109492.003
RM2451
RM2454
RM2551
RM2554
3A
Roof Base
Roof Cover
Lower Side Vent
3103633.XXX*
3103634.XXX*
3109350.XXX*
RM2652
RM2662
RM2663
RM2852
RM2862
RM3862
NDR1062
4A
Roof Base
Roof Cover
Lower Side Vent
3103633.XXX*
3103634.XXX*
3109350.XXX*
GENERAL INFORMATION
Ventilation is one of the requirements for proper cooling
unit operation. The installation should be made in such a man-
ner as to separate the combustion system from the living space
of the mobile home or recreational vehicle. Openings for air
supply or for venting of combustion products should have a
minimum dimension of not less than 1/4 inch.
Proper installation requires one
lower fresh air intake
and one
upper exhaust vent
. Certifi ed installations require one
roof vent
and one
lower side vent.
The ventilation kits shown in this
manual have been certifi ed for use with the different models as
displayed in the “Certifi ed Vent System Kits” table
.
The ventilation kits must be installed and used without
modifi cation! An opening toward the outside at fl oor level
in the refrigerator compartment has be provided for ventila-
tion of heavier-than-air fuel gases. The lower vent of the
recommended kits is provided with proper size openings.
The fl ow of combustion and ventilating air must not be
obstructed.
The lower side vent is fi tted with a panel, which provides
an adequate access opening for ready serviceability of the
burner and control manifold of the refrigerator. This should
be centered on the back of the refrigerator.
* Replace “XXX” with the color code numbers. For color codes,
contact your supplier.
** Alternate instructions forwarded with the Ventilator Kit.
For further information, contact your dealer or distributor.