Filter
Top Products
3
Installation Instructions
x Remove all packaging materials carefully.
x The dishwasher must be installed on a solid, level surface.
x If your sink has a spray wand, it is recommended that the hose be
disconnected and the hole plugged.
A hose that attaches to a spray wand can burst if it is
installed on the same water line as the dishwasher.
• The minimum height clearance required to install your dishwasher on a
counter top surface with overhead cupboards is 45cm (17.7”).
• Make sure there is an electrical supply (outlet) within reach of the
electrical power supply cord (195 cm / 6.3 ft).
• Make sure the water supply/faucet connection is within reach of the inlet
and drain hose assembly (i.e., 58 cm / 22.8”).
Connecting the Dishwasher
Your dishwasher comes equipped with a ‘quick-connect’ assembly
(includes inlet and drain hose). The faucet adapter must be installed on
the faucet before you can connect the dishwasher. This adapter is
included inside your dishwasher.
The faucet adapter is compatible with faucets inclusive of either male
(outside) or female (inside) threaded faucet connections.
• Screw the faucet adapter onto (or into) the faucet tap. Check for leaks
(use Teflon or plumbers tape to eliminate any leaks if necessary).
• Connect the six-sided connection of the drain hose to the drain port
connection on the back of the dishwasher cabinet. To avoid damage to
threads, do not over-tighten.
• Connect the star-shaped connection of the inlet hose to the inlet port on
the back of the dishwasher cabinet. Do not over-tighten.
• Connect the circular connection of the drain hose onto the longer
(bottom) male connection on the quick connect.
• Connect the circular connection of the inlet hose onto the shorter (top)
male connection on the quick connect.
• Attach the quick-connect assembly onto the faucet adapter, by pulling
down the outer locking collar on the quick connect, while pushing the
quick-connect assembly upward onto the faucet adapter.
• Release the locking collar when the quick-connect assembly snaps onto
the faucet adapter. Verify the connection is secure.