Filter
Top Products
5
x Position your portable freezer in a location where there is
proper air circulation and electrical connections.
x Keep the portable freezer away from heat and direct
sunlight if possible.
x This portable freezer is suitable for car use and camping
however, the appliance should not be exposed to rain.
x This portable freezer should not be placed in a built-in or
recessed area. It is designed to be freestanding.
x The normal operation of the freezer depends on heat
radiation from the condenser. For the initial use, remove
all packaging and allow at least 6” of room around the
freezer.
1. Remove all interior and exterior packaging.
2. Position the freezer in a dry and well-ventilated place. Keep the freezer
away from direct sunlight, heaters and corrosive gas.
3. Clean the interior surface with a little bit of lukewarm water and a soft
cloth.
4. When inserting the AC power-cord into the power socket, make sure
the power socket is a grounded 115V~AC / 60Hz socket. Also make
sure that the unit’s grounding prong has not being tampered with.
Note: When inserting the DC power-cord, make sure the input is a
12V DC /
24V power source.
5. When moving the freezer, always use both handles to the carry the
unit as level as possible. This is in order to protect the compressor and
the sealed system.
Movement and Installation Instructions
Proper Location
Because this
unit is
compressor
based, ample
space is
required
around the unit
to allow it to
exhaust
properly.
8
When the ice layer on the inner cabinet sides is over 0.2”, the defrosting
operation should be performed to improve the refrigerating
efficiency. To do this, follow these steps below:
1. Turn off the power, and remove all items located within
the chest.
2. Allow the ice to completely melt.
3. Remove the drain plug and drain all water. Once the unit is defrosted and
all the water has drained out, clean the interior with a soft rag before
using the unit.
Tip: To remove bad odors place a piece of charcoal in the chest
It is normal to hear gurgling sounds caused by the flow of refrigerant when
each cooling cycle ends.
The surface temperature of the compressor can reach 158-194°F when
running.
The noise emitted by the cooling fan on the condenser is a normal
function.
It is normal for the fan in the power supply to run all the time.
Always disconnect the power supply before cleaning. Clean the inside
of the cabinet whenever necessary using a solution of warm water and
baking soda (1 tablespoon to every 2 liters of water). Dry with a soft
cloth.
Do not use steel brushes or aggressive detergents to clean the inner
liner.
CLEANING YOUR
PORTABLE FREEZER
Normal Operating Sounds and Functions
Defrosting and Deodorizing
Never
remove ice
with a sharp
object or
screwdriver.