EdgeStar IB1000SS Ice Maker User Manual


 
i
Important Safety Information
Improper handling can cause serious damage to the EdgeStar ice maker and/or injury to the user. This ice maker is
designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may
invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other
technical data related to this unit. The unit must be used in a properly grounded wall outlet. Please read and follow the
safety information listed below to reduce the risk of fire, electric shock or injury. Installation should only be done by a
licensed plumber.
Electrical Safety
Do not exceed the power outlet ratings.
It is recommended the ice maker be connected on
its own circuit.
The unit must be installed in accordance with
state and local electrical, water and drain codes.
A standard electrical supply (115 V, 60Hz), that is
properly grounded in accordance with the
National Electrical Code and local codes and
ordinances is required.
Use outlets that cannot be turned off by a switch
or pull chain.
Always turn the unit off and unplug it from the
outlet when cleaning.
Unplug the unit if it is not going to be used for an
extended period of time.
Do not operate the unit with a power plug missing
the ground plug, a damaged cord or a loose
socket.
Be sure the ice maker is properly grounded.
Never plug or unplug the unit with wet hands.
Do not bypass, cut or remove the grounding plug.
Do not use extension cords or power strips with
this unit. You may need to contact your electrician
if it is necessary to use a longer cord or if you do
not have a grounded outlet. Do not modify the
power cord’s length or share the outlet with other
appliances.
Do not start or stop the unit by switching the
circuit’s power on and off.
If the power cord is damaged, it must be replaced
by the manufacturer or a qualified technician.
Never open the unit while it is plugged in.
Immediately unplug the unit if it makes strange
sounds, emits smells or smoke comes out of it,
and contact customer service.
Do not remove any part of the casing unless
instructed by an authorized technician.
You should never attempt to repair the unit
yourself.
Contact a customer service for service options if
the unit needs service.
General Safety
To prevent back and other types of injuries, use at
least two people to move and install the ice maker.
Install the ice maker in a well ventilated area where
the ambient temperature is above 55°F and below
90°F.
This unit is designed to be installed indoors, and
protected from rain, sleet, snow, etc.
This unit is not intended to be used by children.
Children should be supervised to ensure that they
do not play with this product.
Never allow children to crawl inside the ice maker.
Do not use this appliance near flammable gas or
combustibles, such as gasoline, benzene, thinner,
etc.
Do not place the unit near heat sources such as
ovens, and grills.
Only use in an upright position on a flat, level
surface and provide proper ventilation.
Do not pinch or kink the water or power supply lines
between the unit and cabinet.
Unit installation must be in accordance with local
plumbing code requirements.
Make sure that the water supply lines and pipes are
not pinched or kinked.
Check for leaks after installation.
Discard the first batch of cubes produced by the ice
maker.
Never turn the water supply tap off while the ice
maker is running.
If the unit has not been used for an extended period,
thoroughly clean it before using it.
Do not leave any cleaning solutions in the unit
Do not use solvent-based cleaning agents or
abrasive solutions on the interior as they may
transmit taste to the ice cubes and damage the
interior.
Only connect a potable water supply.
This appliance is not intended for use by persons,
including children, with reduced physical, sensory or
mental capabilities, unless they have been given
supervision or instruction concerning the use of the
appliance by the person(s) responsible for their
safety.