EdgeStar IB1000SS Ice Maker User Manual


 
3
Installing the Ice Maker
The ice maker should be installed by a licensed plumber to be in accordance with
local electrical and plumbing code requirements.
Before you plug the ice maker in to a power supply, be sure to let it stand upright
for at least 24 hours to allow the compressor’s oils to settle.
Unpacking the Ice Maker
WARNING: Use two more people to move and install the ice maker. Failure to do
so can result in back or other injury.
Carefully remove the packaging materials. Remove any shipping tape and glue
from your ice maker before using. Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape or glue. These products
can damage the surface of your icemaker. IMPORTANT: Do not remove any
safety, warning, or product information labels from your ice maker.
Types of Installation
This ice maker has been designed for free-standing, recessed, or built-in
installation. In every case, there must be adequate ventilation and access
for service.
Free-standing installation:
A free-standing installation will allow you to install the icemaker in any
place you desire provided you have access to a water supply and a drain.
You must follow the stated instructions for electrical requirements, water
supply and drain, and leveling the icemaker.
Recessed installation:
A recessed installation will allow you to install the ice maker under a
counter or in a kitchen cabinet provided the required clearance space
around the ice maker is followed. This installation has the same
requirements as a built-in installation.
Built-in installation:
It is necessary to allow adequate ventilation space around the unit (make
sure there is at least some ventilation room for the back of the unit). The
following additional items must be observed.
1. Place the ice maker in front of the installation location. Remove the
feet and place the unit flat on the floor or on a platform depending on
your installation requirements.
2. The water supply pipe must be plumbed before connecting to the ice
maker. Install the drain line into your drain.
3. Turn on main water supply and tap. Check for water supply
connection leaks. Tighten any connections (including connections at
the tie-in).
4. If the electrical outlet for the ice maker is behind the cabinet, plug in
the ice maker.
5. Push the ice maker into position.
6. Seal all around the cabinet to the floor with an approved caulking
compound.