Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
aWARNINGa
FOLLOW
THESE BASIC PRECAUTIONS TO
REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY WHEN USING YOUR ICE
MAKER.
•
•
•
•
•
READ
ALL INSTRUCTIONS BEFORE USING THE ICE MAKER.
• DANGER:
RISK OF CHILD ENTRAPMENT.
CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST. JUNKED
OR ABANDONED APPLIANCES ARE STILL DANGEROUS.
BEFORE
YOU THROW AWAY YOUR ICE MAKER: TAKE OFF THE DOOR.
NEVER
ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE
APPLIANCE.
NEVER
CLEAN ICE MAKER PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
DO
NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE
HAZARD OR EXPLOSION.
INSTALLATION INSTRUCTIONS
¾ BEFORE USING YOUR ICE MAKER
• REMOVE
THE EXTERIOR AND INTERIOR PACKING.
• CHECK
TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
• 1
ICE BUCKET
• 1
PLASTIC SCOOP
• 1
HOSE, 25 FT.
• 1
INSTRUCTION MANUAL
• BEFORE
CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT
FOR APPROXIMATELY 2 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION
IN THE COOLING SYSTEM FROM HANDLING DURING TRANSPORTATION.
• CLEAN
THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
¾ INSTALLATION OF YOUR ICE MAKER
• THIS APPLIANCE IS DESIGNED TO VENT HOT AIR THROUGH THE FRONT VENT. THIS
ALLOWS FOR INSTALLATION IN A RECESSED OR BUILT-IN APPLICATION, IF DESIRED.
• PLACE YOUR ICE MAKER ON A LEVEL SURFACE THAT IS STRONG ENOUGH TO SUPPORT
THE ICE MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE
SIGNIFICANTLY HEAVIER ONCE IT IS OPERATIONAL AND FULLY LOADED. LEVEL YOUR ICE
MAKER BY ADJUSTING THE LEGS AT THE FRONT OF THE ICE MAKER.
• LOCATE
THE ICE MAKER AWAY FROM DIRECT SUNLIGHT AND SOURCES OF HEAT (STOVE,
HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE FINISH AND HEAT
SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREME COLD AMBIENT
TEMPERATURES MAY ALSO CAUSE THE ICE MAKER MALFUNCTION. THIS ICE MAKER IS
DESIGNED FOR INSTALLATION INDOORS IN “ROOM TEMPERATURE” AMBIENT
CONDITIONS.
• AVOID
LOCATING THE ICE MAKER IN MOIST/HUMID AREAS. TOO MUCH MOISTURE IN THE
AIR WILL CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR REQUIRING FREQUENT
DEFROSTING.
• PLUG
THE ICE MAKER INTO AN EXCLUSIVE PROPERLY INSTALLED GROUNDED WALL
OUTLET. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD. ANY QUESTIONS CONCERNING POWER AND/OR
GROUNDING SHOULD BE DIRECTED TOWARD A CERTIFIED ELECTRICIAN.
1