Filter
Top Products
• THE
STAINLESS STEEL COMPONENTS OF THE DOOR SHOULD BE CLEANED WITH
STAINLESS STEEL CLEANER
• THE
CONDENSER COILS SHOULD BE VACUUMED WHEN THEY ARE DUSTY OR DIRTY.
CAUTION
FAILURE
TO UNPLUG THE ICE MAKER WHEN CLEANING, MOVING, OR SERVICING IT COULD
RESULT IN ELECTRICAL SHOCK OR PERSONAL INJURY.
¾ POWER FAILURE
MOST
POWER FAILURES ARE CORRECTED WITHIN A FEW HOURS AND SHOULD NOT AFFECT
THE TEMPERATURE OF YOUR ICE MAKER IF YOU MINIMIZE THE NUMBER OF TIMES THE DOOR
IS OPENED. IF THE POWER IS GOING TO BE OFF FOR A LONGER PERIOD OF TIME, YOU
SHOULD TAKE THE PROPER STEPS TO DISCONNECT YOUR APPLIANCE.
¾ VACATION TIME/STORAGE
1. SHUT
OFF THE WATER SUPPLY AT THE MAIN WATER VALVE.
2. DISCONNECT
THE WATER SUPPLY LINE FROM THE VALVE.
3. ALLOW
THE UNIT TO RUN FOR AN HOUR OR TWO UNTIL ALL REMAINING ICE CUBES HAVE
BEEN EJECTED AND ALL WATER HAS CYCLED THROUGH THE SYSTEM AND HAS BEEN
MADE INTO ICE CUBES.
4. DISCONNECT
THE UNIT FROM THE MAIN POWER SOURCE.
5. DRY
OUT EXCESS WATER FROM THE ICE MAKER ASSEMBLY
6. LEAVE
THE DOOR OPEN AT LEAST TWO INCHES.
¾ MOVING YOUR ICE MAKER
• SECURELY
TAPE DOWN ALL LOOSE ITEMS INSIDE YOUR ICE MAKER.
• TURN
THE LEVELING SCREWS UP TO THE BASE (THEIR SHORTEST LENGTH POSSIBLE) TO
AVOID DAMAGE.
• TAPE
THE DOOR SHUT.
• MAKE
SURE THE ICE MAKER STAYS IN THE UPRIGHT POSITION DURING
TRANSPORTATION.
¾ ENERGY SAVING TIPS
• THE
ICE MAKER SHOULD BE LOCATED IN THE COOLEST AREA OF THE ROOM, AWAY FROM
HEAT SOURCES, AND OUT OF THE DIRECT SUNLIGHT.
4