Filter
Top Products
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
33
A Cooktop front fixing screws
B Cooktop rear fixing screws
Remove the 2 rear cooktop fixing screws (B) and the 4
front cooktop fixing screws (A).
Remove the screws holding the flue grille stays.
Lift the cooktop clear of the appliance. Replace in
reverse order.
Reassemble in reverse order ensuring that the leads
are reconnected.
Check for correct burner operation.
4. To Remove a Side Panel
Disconnect from electricity supply.
Remove control panel (see 2). Pull the cooker forward.
Remove the 4 retaining screws for each panel (2 at the
front and 2 at the rear). The lower front retaining
screws (one each side) are situated beneath the lower
edge at the front corners of the side panels
Reassemble in reverse order.
5. To Remove Oven Light Switch
Remove control panel (see 2).
NB The old switch may be destroyed during removal.
Remove switch button and old switch from its bezel by
gripping the switch body behind the control panel and
twisting sharply.
The switch bezel can then be removed by folding back
its locking wings and pushing forward. Fit the new
bezel to the control panel by first lining up the raised
key on its body with the cutout in the control panel and
pushing it in from the front. Assemble the new switch to
the bezel by lining up the key sections and pushing
home. Fit the new button by pushing in from the front.
Replace control panel in reverse order and test for
correct operation.
6. To Remove Electronic Timer
Disconnect from electricity supply.
Pull off the timer control buttons and remove the
control panel (See 2). Remove the timer/mounting
bracket assembly from the control panel by removing
the two fixing screws. Remove the timer from its
mounting bracket by depressing the plastic lugs on the
timer case, at the same time pulling the unit forward.
Reassemble in reverse order. When replacing leads
refer to the wiring diagram. Check operation of timer.
Servicing Notes
When servicing or replacing gas carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion. When
checking for gas leaks use a liquid leak detector at all
joints and connections to check for leaks in the system.
Use a product specifically manufactured for leak
detection. Leak testing of the appliance shall be
conducted in accordance to the manufacturer’s
instructions.
CAUTION: DO NOT USE A FLAME TO CHECK
FOR GAS LEAKS.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from electricity supply before commencing
servicing, particularly before removing any of the
following: control panel, side panels, cooktop tray, or
any of the electrical components or cover boxes.
Before electrical reconnection check that the appliance
is electrically safe.
1. To Remove the Hand Rail
Remove the handrail plastic blanking plugs and
remove the 2 end bracket fixing screws.
2. To Remove Control Panel
Disconnect from electricity supply.
Pull off all the control knobs. Remove the hand rail
(see 2) Remove the 2 cross headed screws that were
hidden by the hand rail end brackets.
Open the grill door and R H oven door and remove the
2 screws underneath the control panel.
Pull the control panel forward and support so that the
wires are not strained.
Reassemble in reverse order. When replacing leads
refer to the wiring diagram. Check operation of timer,
ignition, and oven light switches.
3. To Remove the Hotplate top
Disconnect from electricity supply.
Remove the pan supports, cooktop burner caps and
tops. If there are screws holding the cooktop burners to
the cooktop, remove them (not the spark electrode
fixing screws).