Filter
Top Products
15
Ice Service
ICE SERVICE
If your freezer has an automatic icemaker, it will provide a sufficient supply of ice
for normal use. During the initial startup of your freezer, however, no ice will be
produced during the first 24 hours of operation. Automatic ice
makers are also optional accessories that may be installed in
some models at any time. Call your local dealer for information.
Turning Your Ice Maker On
After the plumbing connections have been completed, the
water supply valve must be opened. Place the ice container
under the ice maker, pushing it as far back as possible. Lower
the wire signal arm to its "down" or ON position. New plumbing
connections may cause the first production of ice cubes to be
discolored or have an odd flavor. These first cubes should be
discarded until the cubes produced are free of discoloration
and taste.
Turning Your Ice Maker Off
To stop the ice maker, lift the wire signal
arm until it clicks and locks in the "up" or
OFF position. The ice maker also turns off
automatically when the ice container is full.
If your model has an adjustable freezer
shelf, place the shelf in the lower position,
so that the wire signal arm will hit the ice
when the container is full.
Ice
Container
1” or less
Leveling Bracket
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
Your ice maker is shipped with the wire signal arm in the ON position. To ensure proper
function of your ice maker, hook up water supply immediately or turn ice maker OFF by
lifting the wire signal arm until it clicks and locks in the UP position.
Check the leveling bracket on the ice maker to ensure the ice maker is level. If the gap
between the freezer wall and the ice maker is the same at top and bottom, then ice maker is
level. If the ice maker is not level, loosen the screw and slide the bracket to the correct
position to make it level. Retighten the screw. You will need a 1/4 inch socket wrench for this
task.