Filter
Top Products
11
Timers
Getting Started
Setting clock at power up
You will be prompted to enter the time of day in the
event of a power failure or when you first provide
electric power to your appliance.
• When your appliance is first powered up, 12:00
will flash in the display.
• Enter the time of day using the numeric key
pads and press START to set.
If an invalid time of day is entered, the control will
triple beep. Re-enter a valid time of day and
press START. If CANCEL is pressed your clock
will start with the time set for 12:00.
Select the user pref key to modify the time of day
during other situations such as day light savings.
See example below to set the timer for 5 minutes:
Example
Step Press
3. Press TIMER
1. Press TIMER
2. Enter 5 minutes
Sleep mode
Your control will remain in a sleep mode -Fig.1-
when not in use, unless there is a hot element.
Only the clock will display during this mode. You
will need to wake the control to begin any function.
Awake mode
To awake the control -Fig. 2- touch within the
display panel. If the control panel is not touched
again within 2 minutes, the control will return to the
sleep mode. To start cooking you must select
either the upper oven, lower oven, or a surface
element. User preferences will be available during
this mode as well as timers, oven light and the
control lock.
Wave-Touch™ display modes
NOTE
The timer(s) will not affect the cooking process.
Sleep mode Fig.1
The two timers provided with the oven control
serve as extra reminders in the kitchen. When a
timer reaches less than 1 minute the display will
start to count down in seconds. When the time
runs out the active timer will beep, “00:00” will
display and the timer key will flash.
The following time settings apply to the timers:
• Min. time: 1 minute
• Max. time: 11 hours 59 minutes
To cancel after setting the timer, press the TIMER
key again.
Awake mode Fig.2