Filter
Top Products
Operating Instructions
21
Starting the Wash Programme
0 1. Check that when the dishes and cutlery are loaded into the dishwasher
the spray arms are free to rotate.
2. Open the tap fully.
3. Close dishwasher door.
4. Turn the programme selector clockwise to A
, or B or C (see “Programme
Table“).
1
For interference suppression reasons, only operate the programme
selector with the dishwasher switched off. It is also possible that the
automated addition of detergent will be triggered.
5. Turn the programme selector to the required programme (see “Pro-
gramme Table“).
Power indicator light illuminates. The selected wash programme starts.
The programme selector rotates during the wash programme and indi-
cates the position that has been reached in the programme.
1
If a wash programme has been started even though the tap was closed,
turn the programme selector to the I position, open the tap and start
the programme again.
Changing/Interrupting the Wash Programme
3
Only change or interrupt a wash programme in progress if it is abso-
lutely necessary.
Changing the wash programme
0 1. Turn the programme selector to the I position. Power indicator light
goes out, wash programme stops.
1
Hot steam may escape when the door is opened. Open the door care-
fully.
2. Open dishwasher door and check whether there is still detergent in the
container. Refill the container if necessary.
3. Close dishwasher door.
4. Turn the programme selector clockwise to A
, or B or C (see “Programme
Table“).
5. Turn the programme selector to the required programme (see “Pro-
gramme Table“). Power indicator light illuminates, wash programme
starts.