Filter
Top Products
Installation and Connection Instructions
30
• If the dishwasher is installed under-
neath a kitchen work surface, the
original work surface of the dish-
washer is to be removed as follows:
– Unscrew the screws (1) from the
elbows on the back side.
– Slide the work surface approx.
1cm to the rear (3)
, lift at the
front
(4) and remove.
– Press the work surface retaining
brackets at the position shown in
the diagram
(4) and remove the
bracket at an angle to the rear
(5).
• The dishwasher must also be screwed on tightly to the work surface
or to the adjoining units. This is absolutely necessary so that its sta-
bility is guaranteed according to VDE regulations.
1
If the dishwasher is later used as a free-standing appliance, the original
work surface must be re-mounted.
3 The plinth on free-standing appliances is not adjustable.
4
5