Filter
Top Products
Operating Instructions
11
Adjust the water softener to the setting given in the table that corre-
sponds to the hardness of the water in the area where you live.
1
It is only possible to adjust the water hardness setting when a pro-
gramme is not running. If you have inadvertently started a programme
(an LED indicator is constantly illuminated), then the programme must
be cancelled by pressing the appropriate button.
0 1. The dishwasher must be switched off.
2. Manual setting:
Open the door on the dishwasher.
3. Remove the lower basket from the
dishwasher.
4. Turn the water hardness switch to 0
or 1.
5. Re-position the lower basket.
6. Electronic setting:
Press the water-softener and func-
tion buttons simultaneously and keep
them pressed.
7. In addition press the ON/OFF button.
8. The LED indicator for the water-softener button flashes.
9. Press the water-softener button again.
– The LED indicator for the water-softener button will be illuminated
continuously for an initial 5 seconds and then begin to flash.
– The number of flashes corresponds to the hardness setting.
– The sequence of flashes is repeated several times after a 5 second
pause.
10. Each time you press the water-softener button the hardness setting
will go up by 1.
(Exception: Hardness setting 1 follows hardness setting 5).
– If the hardness setting is changed, the LED indicator for the water-
softener button will confirm the change by remaining illuminated
continuously for 5 seconds and then flashing again.
– The number of flashes corresponds to the new hardness setting.
– The sequence of flashes is repeated several times after a 5 second
pause.
11. Once the hardness setting is correct, press the ON/OFF button.
The hardness setting is then saved.