Filter
Top Products
Operating Instructions
29
...there are problems operating the dishwasher.
...the wash results are unsatisfactory.
The dishes are still dirty.
– The wrong wash programme was selected.
– The dishes were arranged in such a way as to stop the water reaching
all parts of the surface. The dish racks must not be overloaded.
– The filters in the base of the washing compartment are dirty or incor-
rectly positioned.
– Too little or no detergent was used.
– Where there are limescale deposits on the dishes: the special salt con-
tainer is empty or the water softener is incorrectly adjusted.
– The drain hose is connected wrongly.
The dishes are wet and dull.
– Rinse aid was not used.
– The rinse aid container is empty.
Symptom Possible Cause Solution
The programme does
not start.
The dishwasher door has not
been closed properly.
Shut the door.
Mains plug is not
plugged in.
Insert mains plug.
House fuse is faulty. Replace fuse.
For dishwasher models with
delay start timer:
Delay start has been selected.
If dishes are to be washed
immediately cancel delay
start timer.
Spots of rust are visible
in the washing com-
partment.
The washing compartment is
made of anticorrosive stain-
less steel. Rust spots in the
washing compartment are
from particles from outside
the appliance (rust particles
from the water pipe, from
pans, cutlery, etc.). Remove
such spots with a commer-
cially available stainless steel
cleaner.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the salt dispenser lid
securely.
There is a whistling
noise during washing.
The whistling is not a cause
for concern.
Use a different brand of
detergent.