Filter
Top Products
23
Malfunction Possible cause Remedy
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in rhythm 1 short
light signal with approx. 3
second pause in-between:
There is no water entering
the dishwasher.
The tap is blocked or furred
with lime-scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
dishwashing cycle that
has started;
then abort the dish-
washing cycle (see sec-
tion: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water inflow hose has not
been correctly positioned.
Check hose installation.
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in rhythm 2 short
light signals one after anoth-
er.
The sink outlet is blocked. Clean out sink outlet.
Water drain hose has not
been correctly positioned.
Check hose installation.
the indicator for the end of
the dishwashing cycle is
flashing in rhythm 3 short
light signals one after anoth-
er.
The anti-flood system has
been triggered.
Turn off the tap and
contact the Customer
Care department.
The cycle is not starting.
The mains plug is not
plugged in.
Plug in mains plug.
A fuse in the house’s wiring
system is defective.
Replace fuse.
For dishwasher models with
a delay start timer:
A start time has been select-
ed.
If the dishes are to be
washed immediately,
cancel the delay start.