Filter
Top Products
33
Position and connection instructions
Water inlet
The dishwasher is equipped with safety features which are to
prevent the water from going back to the fresh water system.
These features are according to current water technical safety
regulations.
The dishwasher must be connected to a cold water supply and the pres-
sure should be between 80-1000 kPa (0,8 - 10 bar).
It is important to have a tap or stopcock,
positioned close to the dishwasher and with
easy access. Special mixer taps with dish-
washer connections are available, as well
as adaptors for older mixer taps. Connect
the inlet hose to a tap with a 3/4" pipe thread.
The inlet hose must not be joined onto any
form of extension hose. If it is too short, the
entire hose must be replaced with a longer
highpressure hose, specially designed for
the purpose. The end of the hose, which is
connected to the dishwasher can be turned
in any direction. Loosen the retaining nut,
turn the hose, then retighten the nut.
Check that the nut is tight before the
machine is moved into position.
Use only the inlet hose supplied to
the dishwasher, do not reuse the old
inlet hose.
english AEG F45250Vi UK 2-12-17 16.19 Sidan 33