Filter
Top Products
Electrical connection
The dishwasher is supplied with a lead and electrical plug for connection
to a 230 V earthed wall socket, which should be easily accessible and
protected by a 13 A fuse.
Before any work is carried out on the dishwasher, it must be
isolated from the electric mains supply, for example by removing
the plug from the wall socket.
Permanent electrical installation must be carried out by an
authorized electrician.
WARNING:THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure
not be observed.
If the plug that is fitted to your appliance is not suitable for your socket
outlet, it must be cut off and the appropriate plug fitted. Remove the fuse
from the cut off plug. The cut off plug should then be disposed of to prevent
the hazard of shocks in case it should be plugged into a 13 amp socket in
another part of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires
in the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the terminal in the plug
which is marked with the letter «E» or the earth symbol or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is mar-
ked with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is marked
with the letter «L» or coloured red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13 amp BSI362 fuse. Only ASTA or BSI approved
fuses should be used.
13 AMP
GREEN & YELLOW
13 AMP FUSE
BLUE
BROWN
CORD CLAMP
35
Position and connection instructions
english AEG F45250Vi UK 2-12-17 16.19 Sidan 35