Filter
Top Products
31
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can
install it under a close fitting sink unit or a
pre-existing top, providing the dimensions of
the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull from the front and slide
out the rear slots, lifting the worktop.
Insert the machine after adjusting height and
levelling with the adjustable feet. When inserting the machine, ensure that the water
inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the
cabinet.
If the door does not close correctly, loosen or tighten
the adjustable feet until the machine is perfectly level.
820
570 - 600
600
IN05
Installation and connection instructions
IN06
IN07
152976 17/1 15-09-2001 9:10 Pagina 31