Filter
Top Products
Electrical Connection
This appliance must be earthed.
The manufacturer declines any responsibilĆ
ity should this safety measure not be obĆ
served.
Before switching on make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
Changing a fuse
Your appliance is supplied with a 13 amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved (BS1363A) fuse must
be used,
Should the plug need to be replaced for any reason,
proceed as described below.
The wires on the mains lead are coloured in accordance
with the following code.
Green and Yellow -Earth
Blue -Neutral
Brown -Live
The wired coloured green and yellow must be connecĆ
ted to the terminal marked with the letter "E" or by the
earth symbol or coloured green and yellow.
The wired coloured blue must be connected to the terĆ
minal "N" or coloured black.
The wire cooured brown must be connected to the terĆ
minal marked "L" or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
A cut off plug inserted into a 13amp socket
is a serious safety (shock) hazard.
Ensure that the cut of plug is disposed of saĆ
fely.
Permanent connection
In the case of permanent connection it is necessary
that you install a double pole switch between the apĆ
pliance and the electricity supply (mains), with a miniĆ
mum gap of 3mm between the switch contacts and a
type suitable for the required load in compliance with
the current electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
153 0409 20 / 09.99
AEG