Electrolux 55GX3 Cooktop User Manual


 
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom, shower
room or garage. It is essential that the appliance is positioned as stated below. The appliance must be a
minimum of 20mm from the rear wall (note that this dimension is provided by the inlet elbow). Shelves, wall
cabinets and cooker hoods must not be fitted closer that 500mm to the top of the grill canopy or within 100mm
of the sides of the grill. Curtains must not be fitted immediately behind the appliance or within 200mm of the
sides of the grill. If fitted next to or between two base units a minimum space of 1mm must be left between
the units and the sides of the appliance. The hotplate must be set to a minimum of 7mm above the adjacent
units (note that the levelling feet fitted to the appliance will achieve a nominal height to hotplate level of
907mm -5+13mm). Base units not meeting the above conditions must be a minimum of 100mm away from the
hotplate.
L.P.G. cookers MUST NOT be installed below ground level, i.e in a basement, or aboard any boat, yacht or
other vessel.
INSTALLATION
1. PARTS REQUIRED
The loose hotplate parts are packed in the polystyrene fitment on
the top of the hotplate. The grill pan, grill pan handle, fixing screws
and splashplate fixing screws can be found in the oven pack which
is located in the oven compartment. The grill pan requires
assembly before use (see Fig. 1).
2. GRILL ASSEMBLY
The two splashplate screws marked A (see Fig. 2a) should be
screwed into the back of the appliance about halfway in. Engage
the keyhole slots in the splashback behind the two screws taking
care not to trap the H.T. wire (see Fig. 2b).
Insert the four splashplate screws marked B (see Fig. 2b).
Tighten 6 off splashplate screws (see Fig. 2b).
Connect the grill supply union at the back of the appliance and pull
the grill H.T. lead through the opening in the splashplate. Feed
lead through the hole in the top right hand side of the splashplate
and connect on to the grill electrode. (see Fig. 2b).
39
Fig.2a
Fig.1
Fig.2b
GRILL PAN HANDLE
ASSEMBLY:-
The two grill pan handles should
be assembled as Fig.1 and
secured with the
four screws
provided.