Filter
Top Products
Prior to using for the first time10
Setting electronically:
1. Press the ON/OFF button.
3 If the only LED indicator illuminated is one that belongs to a programme button,
this means that this dishwashing cycle has been activated. The dishwashing
cycle must be deselected:
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
The LED indicators of all the programme buttons that can be selected light up.
2. Press function buttons 1 and 2 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The multidisplay will indicate the hardness setting.
4. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control in
dicator for special salt.
Water hardness Adjusting the hardness setting Indication on
the multidis
play
in °d
1)
1) (°d) German degree, measure of the hardness of water
in mmol/l
2)
2) [mmol/l] millimol per litre, international unit for water hardness
Range Manual Electronic
51 70
43 50
37 42
29 36
23 28
9,0 12,5
7,6 8,9
6,5 7,5
5,1 6,4
4,0 5,0
IV
2*
10
3)
9
8
7
6
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
10L .
9L
8L
7L
6L
19 22
15 18
3,3 3,9
2,6 3,2
III
5*
4
5L
4L
1
11 14 1,9 2,5 II 3 3L
4 10 0,7 1,8 I/II 2 2L
below 4 below 0.7 I
1
no salt
necessary
1L