Filter
Top Products
Make sure that there are no kinks in the water inlet hose and that the water inlet hose is
not squashed or entangled.
Fit the hose nut correctly to prevent water leaks.
CAUTION!
Do not connect the appliance to new pipes or pipes that have been not used for a long
time. Let the water run for some minutes, then connect the inlet hose.
The water inlet hose is double-walled and has an inner mains cable and a safety valve. The
water inlet hose is under pressure only while the water is running. If there is a leak in the
water inlet hose, , the safety valve interrupts the running water.
Be careful when you install the water inlet hose.
WARNING!
• The mains cable is in the double-walled inlet hose. Do not immerse the water inlet hose
or the safety valve in water.
• Do not attempt to shorten the inlet hose.
• If the water inlet hose or the safety valve is damaged, immediately turn off the power
and remove the mains plug from the mains socket.
• Only a qualified Service Engineer can replace the water inlet hose with safety valve.
WARNING!
Dangerous voltage
In order to pass the safety valve through the kitchen cabinets, an opening of at least 45mm
x 90mm is needed.
Water drain hose
Use the supplied hose clamp to connect the water drain hose to the sink.
The highest point of the drain hose must be no more than 60 cm from the floor and must
have a continuous fall to the plumbing connection.
The drain hose can be lengthened using additional lengths and connectors. These must be
purchased from Electrolux Spare Parts. The extension length must not exceed 2 metres.
The drain hose must be free of kinks and obstructions.
Remove the sink plug when the appliance drains the water to prevent that the water goes
back into the appliance.
Water connection
33