Filter
Top Products
Operating instructions
35
Something not working
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
Important: If you call out an engineer to a fault listed below or to
repair a fault caused by incorrect use or installation a charge will be
made, even if the appliance is in guarantee.
...a flashing fault code appears
The dishwasher will not start or stops during operation and a sequence
of intermittent audible signals are heard.
The point-shaped optical signal on the floor beneath the dishwasher’s
door is flashing (not visible if the appliance has been installed higher
up with a furniture door mounted flush).
Open the dishwasher’s door.
The intervention of an alarm is indicated by:
- the continuous flashing of the indicator light of the running
programme,
- in the digital display is visible a fault code (as described in the chart).
Carry out the following suggested corrective actions.
Fault code / Malfunction
in the digital display
appears
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the sink spigot.The sink spigot is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Possible cause Solutions
in the digital display
appears
The dishwasher will not
drain
Close the water tap and
contact your local Service
Force Centre.
Anti-flood device is activated.
in the digital display
appears
152955 32/0en 31-03-2005 9:04 Pagina 35