Filter
Top Products
Installation
9
Levelling
The appliance must be level. Level the
appliance by adjusting the two
adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be
removed.
Reversing the Door
The side at which the door opens can be changed from the right side(as
supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.
Tilt the appliance backwards, resting the top edge of the appliance on a stool
or something similar.
Unscrew the adjustable feet
situated on both sides at the
front (2 pieces). Remove the
lower door hinge plate by
unscrewing the 3 retaining
screws.
Remove the hinge pin from the
bottom of the door.
Slot the hinge pin into the hole
in the hinge plate.
Take the door off.
Refit the upper hinge pin into
the opposite location.
Fit the door in place on the
hinge pin.
Slot the hinge pin into the hole
in the hinge plate and relocate
the hinge assembly to the
opposite location and refit using
the retaining screws.
Refit the bottom hinge plate
assembly on the opposite side,
taking care that the edge of the
door is parallel with the side of
the cabinet.
2
1