Filter
Top Products
7
Operating and indicator panel
A
B
C
D
E
F
G
H
I
+
°C
°C
-
ON/OFF
FROSTMATIC ALARMOFF
A. Mains pilot indicator (green)
B. Freezer button ON/OFF
C. Temperature setting button (+)
D. Temperature display
E. Temperature setting button (-)
F. FROSTMATIC function "on" indicator (yellow)
G. FROSTMATIC button
H. Alarm reset light
I. Alarm reset button
Temperature setting buttons
The temperature is adjusted using the “C“ and “E“ buttons. These buttons are
connected to the temperature display.
• The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the DESI-
RED temperature (Temperature display flashes) by pressing one of the two
buttons, “C“ or “E“.
• Each time one of the two buttons is pressed again the DESIRED temperatu-
re is adjusted by 1 °C. The DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL tem-
perature.
DESIRED temperature means:
The temperature that has been selected for inside the freezer. The DESIRED
temperature is indicated by flashing numbers.
14
Heavy build up of frost, possi-
bly also on the door seal.
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
The freezer temperature is not
sufficient, red light lights up,
temperature signal sounds
The appliance is near a heat
source.
Please look in the "Installation
location" section.
Disturbance on the appliance
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
Unusual noises.
The appliance is touching the
wall or other objects.
Appliance is not level.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend
the component out of the
way.
Move the appliance slightly.
The feet are not adjustable.
The compressor starts after a
period of time.
This is normal, no error has
occurred.
The compressor does not start
immediately after changing
the temperature setting.
Malfunction Possible Cause Remedy