Filter
Top Products
15
Fitting the Hood Body
Before starting to fi x the hood body,
tighten the two screws Vr located on the
top of the hood body.
Hook the hood body onto the two
4.2x44.4mm screws item 12a.
Fully tighten the screws item 12a.
Using a screw driver and spirit level,
adjust the screws item Vr until the hood
body is level.
Extraction
The cooker hood is more effective when used in
the extraction mode (ducted to the outside).
Venting kits may be purchased through your
retailer or DIY store, and must be ducted to an
outside vent of Ø125mm (5”) or Ø150mm (6”).
The ducting used must be manufactured from
fi re retardent material conforming to the relevant
British Standard or DIN 4102-B1.
When the cooker hood is ducted to the outside the
charcoal fi lter must be removed.
Recirculation
The cooker hood is supplied specifi ed for use
in the recirculation mode, with the charcoal fi lter
fi tted.
In the recirculation mode contaminated air is
passed through the charcoal fi lter to be purifi ed
and recirculated into the kitchen through the grille
outlets on either side of the chimney.
To assemble the recirculation duct, place the
recirculation outlet connection item 15 into the
support item 7.3.
Insert the extension ducts item 14.1 into either
side of the recirculation outlet item 15 ensuring
the connections are vertically and horizontally
aligned with the outlets in the chimney.
Connect the recirculation oulet item 15 to the
outlet on top of the hood body using either a piece
of Ø125mm or Ø150mm fl exible or rigid pipe.
Rigid pipe is strongly recommended and should
be used where possible as this will ensure the
best performance while lowering noise.
ø 150
14.1
15
12a
Vr
INSTALLING THE COOKER HOOD