Filter
Top Products
70
• For extractor versions (13A), connect the other end of the exhaust pipe to the flue.
For filter versions (13F), fit deflector F to the support and secure it to the bracket
supplied using 4 screws, then connect the exhaust pipe to the connection ring located
on the deflector.
• Fit the nuts with fixing hooks (14) supplied inside the top and bottom sections of the
flues at the rectangular slots. A total of 10 nuts must be fitted.
• Join the two top sections of the flue to cover the support (15) so that one of the slots on
the sections is situated on the same side of the control panel and the other on the
opposite side. Screw the two sections together with 4 screws (2 each side- see the
plan diagram for joining the two sections).
• Fix the top flue assembly to the support, near the ceiling, with two screws (16 - one
each side).
• Carry out electrical connection of control panel and bulbs (17).
• Join the two bottom sections of the flue covering the support (18) using 6 screws (3
each side, see the plan diagram for joining the two sections).
• Insert the bottom section of the flue in its seat so that it completely covers the motor
compartment and electrical connection box, then ensure it from inside the hood using
two screws (19).
• Apply the 2 tabs (20 - supplied) to cover the fixing points of the bottom flue
(CAUTION! THE BOTTOM FLUE TABS ARE THE NARROWER AND
SHALLOWER ONES).
The wider and deeper tabs are those used for the top flue, and must be cut to size.
• Turn the mains power on again at the central electrical panel and check for correct
hood operation.